Ford Turn Signal Wire Colors

Last Updated on by

Most people don’t know that there are different wire colors for the turn signals on a Ford car. The wire colors can be different depending on the model and year of the car. Here is a list of the most common wire colors for Ford turn signals:

– Green – Yellow – Brown

– Gray Knowing these wire colors can help you when troubleshooting your turn signals. If you have ever had a turn signal that didn’t work, then you know how frustrating it can be.

Hopefully this information will help you get your turn signals working again.

If you’re looking to wire up your Ford’s turn signals, you’ll need to know the wire colors. Here’s a quick guide to help you out: The main wire for the turn signal switch is black with a white stripe.

This wire will run from the switch to the flasher unit. The left turn signal wires are green and yellow. The green wire goes to the front left turn signal, and the yellow wire goes to the rear left turn signal.

The right turn signal wires are red and brown. The red wire goes to the front right turn signal, and the brown wire goes to the rear right turn signal.

F100 Steering Column Wiring / Turn Signals

Ford Turn Signal Wire Colors


What Color is the Turn Signal Wire?

The turn signal wire is most likely going to be green. But, it could also be brown or yellow.

Ford Wire Related Article Below:
Rear Light Wiring Ford Tail Light Wire Colors
Ford F250 Tail Light Wire Colors
Diagram Ford F150 Ground Wire Location
2003 Ford F150 Speaker Wire Colors
Ford Wire Harness Color Code

Which Wire is Positive on Turn Signal?

Assuming you are talking about a standard American car: The wire that is positive on the turn signal is the green wire. This is because in America, the standards for wiring cars is that green wires are always used for the right turn signal and yellow wires are used for the left turn signal.

What is the Blue Wire on a Turn Signal?

The blue wire on a turn signal is the one that controls the left-hand side of the brake light. When you press the brakes, the blue wire sends a signal to the left-hand side of the brake light, telling it to come on.

How Do You Wire a Turn Signal Light?

Assuming you would like a blog post discussing how to wire a turn signal light: Most vehicles have their turn signal lights located on the front and back of the car. The front signals are usually located on the fenders, while the rear signals are either on the trunk or rear bumper.

In order to wire your turn signal lights, you will need to tap into the vehicle’s electrical system. The first thing you will need to do is find the correct wires. The wire for the left turn signal will be green, while the right turn signal will be yellow.

You will also need to find a ground wire, which is typically black. Once you have found these wires, use a circuit tester to make sure they are live wires. Next, use butt connectors to splice into these live wires.

Make sure that each butt connector is properly crimped so that there is no chance of it coming loose. Then, run your new wires to where your turn signal lights will be mounted. At this point, you can either solder or use twist-on connectors to attach your new wires to theturn signal lights themselves.

Finally, test your work by turning on your hazard lights and then activating each turn signal individually. If everything is working properly, both sets of turn signals should blink at the same time.


If you’re a Ford owner, you may be wondering what the wire colors mean for your turn signals. Here’s a quick rundown of what each color means: Red – Stop/Brake Lights

Yellow – Left Turn Signal Green – Right Turn Signal Brown – Tail Lights

Knowing the wire colors can be helpful when troubleshooting electrical issues with your turn signals. If you have any questions, feel free to contact your local Ford dealer for more information.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *